Bay Networks Remote Annex Instrukcja Użytkownika Strona 12

  • Pobierz
  • Dodaj do moich podręczników
  • Drukuj
  • Strona
    / 38
  • Spis treści
  • BOOKMARKI
  • Oceniono. / 5. Na podstawie oceny klientów
Przeglądanie stron 11
Configuring the Nortel Networks Remote Access Concentrators and the DMS-10 for Remote Access.March 31, 1999 12
SITE BASE
RMB NO
TRK CAPB CE 01 1 04 1 01
CAPB CE 01 1 04 1 02
CAPB CE 01 1 04 1 03
CAPB CE 01 1 04 1 04
...
...
CAPB CE 01 1 04 1 23
With the LTG assigned a Route will need to be added to the LTG. This is done as in the
DCM example in Overlay ROUT. Below is an example of a ROUT in this case rout 601.
ROUT 601
ALTR BUSY
TYPE PRI
CTYP NONE
CHG YES
LTG 2
DEL 0
APFX NONE
PGNC YES
5.5 Introduction RAC 8000 Setup
Once the RAC has been mounted in its frame and it has been powered up according to the
documentation provided with the unit. A terminal device, such as a PC running Hyperter-
minal or equivalent must be used to setup the device. It is adviseable to start a log session
when making changes so a record can be made.
This description is intended to provide a focused approach to setting up the RAC to work
with a DMS-10. It is not to replace the appropriate documentation supplied by Bay Net-
works. The Author has made an attempt to layout the important commands in a manner
that they can be more easily understood based on his experience. It makes no attempt to
set up all the extensive features available on the RAC, just to provide the basic features for
internet access off a DMS-10.
5.5.1 Command Line Interface
The Command Line Interface, CLI, should be understood prior to any setting up of param-
eters since its navigation is required. Figure 6 shows a overview of the Command Line
interface on the RAC. There are two entry points to the monitor. The initial entry point is
through the console serial port of the RAC. The second entry point in through telnet over
the ethernet port. Initially the RAC must be setup using the serial console port to set up the
IP address, subnet mask and boot addresses if applicable.
Przeglądanie stron 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 37 38

Komentarze do niniejszej Instrukcji

Brak uwag